- Home
- Problems
- Washer Repair
- Washer Won't Start
Washer won't start or turn on?
A washer that's dead, or that lights up but won't begin a cycle, is usually a lid lock, door lock, a control board, a user interface or power. We check in order and replace only what failed.
- Most likely cause
- A failed lid lock or door lock, or a control board
- Typical repair time
- One visit, 30–60 minutes
- Service call
- $89 diagnostic, credited to the repair
Why it's happening, in order of likelihood
Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.
- 1
Lid lock or door lock
The control won't start a cycle until the lock confirms. A failed lock gives a flashing lid-lock light or a code.
- 2
Control board or user interface
A dead panel, unresponsive buttons or a cycle that starts and stops immediately.
- 3
Power: outlet, cord, breaker
Houston laundry rooms often share a circuit; a tripped breaker or a dead GFCI is the first check.
- 4
Line filter / noise filter
A small module on the power cord that fails and kills all power to the machine.
- 5
Water supply (no fill, so no cycle)
Some machines appear not to start when they're waiting on water that isn't coming.
- 6
Timer (older mechanical machines)
Worn contacts in the timer.
Check these before you call
Safe, no-tools checks. If none of them solves it, the next step is a technician.
- Check the breaker and try another device in the outlet.
- Make sure the lid or door is fully closed and the water valves are open.
- Unplug the washer for 5 minutes to reset the control, then try again.
- Check for child lock or a delay-start setting on the panel.
Parts we typically replace
- Lid lock
- Door lock
- Main control board
- User interface board
- Line filter
- Timer
Brand-specific notes
Repair or replace?
Locks and filters are cheap. A control board on an older budget machine is a judgment call we'll make with you.
What happens on the visit
Describe the symptom
Tell us the brand, model and what it's doing. A photo of the model tag helps.
We diagnose, you approve
$89 diagnostic, credited to the repair. Flat-rate quote before any work.
Fixed, usually that visit
Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.
Questions about this problem
My washer lights up but nothing happens when I press start. Why?
Related washing machine problems
Washer Not Draining
An obstructed or failed drain pump.
See causes & fixesWasher Not Spinning
A failed lid lock, door lock or drive component.
See causes & fixesWasher Leaking Water
A torn door boot (front load) or a failed drain pump or hose.
See causes & fixesWasher Not Filling
Clogged inlet screens or a failed water inlet valve.
See causes & fixesWasher Shaking or Walking
Worn suspension rods (top load) or shock absorbers (front load).
See causes & fixesWasher Making Grinding or Squealing Noise
A worn drive component, bearing or a foreign object in the tub.
See causes & fixes