- Home
- Problems
- Washer Repair
- Washer Making Grinding or Squealing Noise
Washer grinding, squealing or roaring?
Noises change with the cycle: a grind during agitate, a squeal during spin, a roar that gets louder as the tub speeds up. Each points to a specific part, from a $20 coupling to a tub bearing.
- Most likely cause
- A worn drive component, bearing or a foreign object in the tub
- Typical repair time
- One visit, 45–90 minutes
- Service call
- $89 diagnostic, credited to the repair
Why it's happening, in order of likelihood
Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.
- 1
Tub bearings
A roar or rumble that rises with spin speed, sometimes with rust-colored stains or a leak underneath. The bearing and seal are replaced together.
- 2
Motor coupling or drive block
A grinding during agitation on older Whirlpool direct-drive machines; the agitator barely moves.
- 3
Drive belt or pulley
Squealing on spin from a glazed belt or a worn pulley.
- 4
Foreign object between tubs
A bra wire, coin or bobby pin scraping between the inner and outer tub. Removed through the pump or by lifting the tub.
- 5
Drain pump
A grinding during drain means debris in the pump impeller.
- 6
Agitator dogs or clutch
A ratcheting or grinding from the agitator on top loaders; clutch chatter on spin.
Check these before you call
Safe, no-tools checks. If none of them solves it, the next step is a technician.
- Note when the sound happens: agitate, spin or drain.
- Spin the empty inner tub by hand; roughness or play means the bearing.
- Check the pump filter for debris on front loaders.
Parts we typically replace
- Tub bearing & seal
- Motor coupling
- Drive belt
- Drive pulley
- Drain pump
- Agitator dogs
- Clutch
Brand-specific notes
Repair or replace?
Couplings, belts and pumps are repairs. A bearing on a budget machine over 8 years old may favor replacement.
What happens on the visit
Describe the symptom
Tell us the brand, model and what it's doing. A photo of the model tag helps.
We diagnose, you approve
$89 diagnostic, credited to the repair. Flat-rate quote before any work.
Fixed, usually that visit
Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.
Questions about this problem
Is it safe to use a washer with a bad bearing?
Related washing machine problems
Washer Not Draining
An obstructed or failed drain pump.
See causes & fixesWasher Not Spinning
A failed lid lock, door lock or drive component.
See causes & fixesWasher Leaking Water
A torn door boot (front load) or a failed drain pump or hose.
See causes & fixesWasher Won't Start
A failed lid lock or door lock, or a control board.
See causes & fixesWasher Not Filling
Clogged inlet screens or a failed water inlet valve.
See causes & fixesWasher Shaking or Walking
Worn suspension rods (top load) or shock absorbers (front load).
See causes & fixes