Houston · Harris, Fort Bend & Montgomery counties
Mon–Sat 7am–7pmSame-day & next-day appointments (713) 548-7587
  1. Home
  2. Problems
  3. Washer Repair
  4. Washer Not Filling
Washer Repair · Houston, TX

Washer not filling with water or filling slowly?

No water or a trickle usually means clogged inlet screens, a failed water inlet valve or a pressure switch problem. Houston's sediment-prone supply lines clog the screens more than you'd think.

One visit, 30–45 minutes Same-day in most of Houston 1-year parts, 90-day labor warranty
Quick diagnosis
Most likely cause
Clogged inlet screens or a failed water inlet valve
Typical repair time
One visit, 30–45 minutes
Service call
$89 diagnostic, credited to the repair

Why it's happening, in order of likelihood

Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.

  1. 1

    Clogged inlet screens

    Small mesh screens where the hoses meet the valve catch sediment and scale until flow drops to a trickle.

  2. 2

    Water inlet valve

    One or both solenoids fail; hot or cold doesn't fill, or fill is very slow.

  3. 3

    Water supply valves and hoses

    A valve not fully open, a kinked hose or a flood-stop hose that tripped.

  4. 4

    Pressure switch or pressure hose

    If the control thinks the tub is already full, it won't fill.

  5. 5

    Lid lock / door lock

    Many machines won't fill until the lid is locked.

  6. 6

    Control board

    A failed valve relay.

Check these before you call

Safe, no-tools checks. If none of them solves it, the next step is a technician.

  • Turn both supply valves fully open and check the hoses for kinks.
  • Shut off water, remove the hoses and clean the inlet screens.
  • Confirm the lid or door locks when the cycle starts.

Parts we typically replace

  • Water inlet valve
  • Fill hoses
  • Pressure switch
  • Lid lock
  • Control board

Brand-specific notes

  • LGLG shows IE for a fill fault.
  • SamsungSamsung shows 4C/4E.
  • WhirlpoolWhirlpool and Maytag show LF or F8 E1 for long fill.

Repair or replace?

Always a repair.

What happens on the visit

1

Describe the symptom

Tell us the brand, model and what it's doing. A photo of the model tag helps.

2

We diagnose, you approve

$89 diagnostic, credited to the repair. Flat-rate quote before any work.

3

Fixed, usually that visit

Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.

Questions about this problem

Why does my washer fill with only cold water?
The hot side of the inlet valve has failed, or the hot supply valve is off. On some cycles cold-only is by design.

Related washing machine problems

Washer trouble? Same-day help.

Call or text (713) 548-7587 for a same-day appointment anywhere in Greater Houston. $89 diagnostic, credited toward your repair.

Call nowBook online