Houston · Harris, Fort Bend & Montgomery counties
Mon–Sat 7am–7pmSame-day & next-day appointments (713) 548-7587
  1. Home
  2. Problems
  3. Microwave Repair
  4. Microwave Not Heating
Microwave Repair · Houston, TX

Microwave runs but doesn't heat?

A microwave that lights up, turns the plate and hums but leaves food cold has a failure in the high-voltage circuit: the diode, the capacitor, the magnetron or a door interlock switch. This is not a DIY repair; the capacitor holds a dangerous charge.

One visit, 30–60 minutes Same-day in most of Houston 1-year parts, 90-day labor warranty
Safety first. Microwaves store a lethal charge in the high-voltage capacitor even when unplugged. Don't open the cabinet.
Quick diagnosis
Most likely cause
A failed diode, door switch or magnetron
Typical repair time
One visit, 30–60 minutes
Service call
$89 diagnostic, credited to the repair

Why it's happening, in order of likelihood

Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.

  1. 1

    High-voltage diode

    An inexpensive part that fails open or shorted; the microwave runs normally but produces no heat, sometimes with a hum.

  2. 2

    Door interlock switches

    Three switches confirm the door is closed. One worn switch can allow the microwave to run while disabling the magnetron.

  3. 3

    Magnetron

    The tube that generates microwaves wears out, often with a loud hum or a burning smell.

  4. 4

    High-voltage capacitor or transformer

    A failed capacitor or a shorted transformer; the microwave may hum loudly or trip the breaker.

  5. 5

    Inverter board (Panasonic and some others)

    Reported as H97/H98 on Panasonic.

  6. 6

    Control board

    No signal to the high-voltage circuit.

Check these before you call

Safe, no-tools checks. If none of them solves it, the next step is a technician.

  • Test with a cup of water for 1 minute; if it's not hot, the high-voltage circuit has failed.
  • Check that the microwave isn't in demo mode or set to very low power.
  • Note any error code.

Parts we typically replace

  • High-voltage diode
  • Door interlock switches
  • Magnetron
  • High-voltage capacitor
  • Inverter board
  • Control board

Brand-specific notes

  • PanasonicPanasonic H98 is an inverter/magnetron fault.
  • GE AppliancesGE over-the-range microwaves: diode and door switches most often.
  • SharpSharp microwave drawers: door switches and the drawer interlock.

Repair or replace?

Over-the-range, built-in and drawer microwaves: repair. Basic countertop units: replace.

What happens on the visit

1

Describe the symptom

Tell us the brand, model and what it's doing. A photo of the model tag helps.

2

We diagnose, you approve

$89 diagnostic, credited to the repair. Flat-rate quote before any work.

3

Fixed, usually that visit

Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.

Questions about this problem

Why does my microwave hum loudly and not heat?
A shorted diode or a failing magnetron or capacitor. Stop using it until it's checked.

Related microwave problems

Microwave trouble? Same-day help.

Call or text (713) 548-7587 for a same-day appointment anywhere in Greater Houston. $89 diagnostic, credited toward your repair.

Call nowBook online