- Home
- Problems
- Ice Maker Repair
- Ice Maker Not Making Ice
Ice maker not making ice?
No ice usually means no water reaching the mold, or an ice maker that isn't cycling. We check water pressure, the inlet valve, the fill tube, the filter and the ice maker itself, and replace what failed.
- Most likely cause
- A frozen fill tube, a weak water inlet valve or a worn ice maker module
- Typical repair time
- One visit, 30–60 minutes
- Service call
- $89 diagnostic, credited to the repair
Why it's happening, in order of likelihood
Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.
- 1
Frozen fill tube
The small tube that drops water into the ice mold freezes solid when the inlet valve weeps or the freezer runs very cold. No water, no ice.
- 2
Water inlet valve
The valve weakens with age and mineral scale and can't deliver enough water during the short fill window, leaving tiny or hollow cubes and then nothing.
- 3
Clogged or wrong water filter
An overdue filter, or an aftermarket filter that restricts flow, starves the ice maker before it affects the dispenser.
- 4
Ice maker module failure
The motor, thermostat or control inside the ice maker fails and the unit never cycles. On many models the whole assembly is replaced.
- 5
Low water pressure or kinked supply line
Ice makers need roughly 20 psi minimum. A saddle valve, a kinked line behind the fridge or a reverse-osmosis system without a booster pump can starve them.
- 6
Freezer too warm
Most ice makers won't cycle until the mold reaches about 15°F. If the freezer is above 10°F, fix the cooling problem first.
Check these before you call
Safe, no-tools checks. If none of them solves it, the next step is a technician.
- Confirm the ice maker is switched on (arm down or switch on) and the freezer is at 0°F.
- Replace an overdue water filter and run a few quarts through the dispenser.
- Check the supply line behind the fridge for kinks and make sure the shutoff valve is fully open.
- Give it 24 hours after any change; ice makers are slow.
Parts we typically replace
- Ice maker assembly
- Water inlet valve
- Fill tube / heater
- Water filter head
- Ice level sensor
Brand-specific notes
- SamsungSamsung French door ice makers frost over because of air leaks into the ice room. We seal the ice room and replace the ice maker, which stops the problem from recurring.
- LGLG Craft Ice makers have a separate module for sphere ice; it can fail independently of the standard ice maker.
- GE AppliancesGE side-by-side models often need an auger motor or dispenser solenoid when ice is made but won't dispense.
- FrigidaireFrigidaire side-by-side ice makers are a frequent, inexpensive replacement.
Repair or replace?
Ice maker repairs are inexpensive relative to the refrigerator; replace the ice maker, not the fridge.
What happens on the visit
Describe the symptom
Tell us the brand, model and what it's doing. A photo of the model tag helps.
We diagnose, you approve
$89 diagnostic, credited to the repair. Flat-rate quote before any work.
Fixed, usually that visit
Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.