Houston · Harris, Fort Bend & Montgomery counties
Mon–Sat 7am–7pmSame-day & next-day appointments (713) 548-7587
  1. Home
  2. Problems
  3. Washer Repair
  4. Washer Stuck on a Cycle
Washer Repair · Houston, TX

Washer stuck on a cycle or running for hours?

A washer that loops on rinse, shows the same time remaining for an hour, or never finishes is usually waiting on something: water level, temperature, balance or drain. Finding what it's waiting on is the repair.

One visit, 30–75 minutes Same-day in most of Houston 1-year parts, 90-day labor warranty
Quick diagnosis
Most likely cause
A pressure sensor fault, slow drain or an unbalance the control can't correct
Typical repair time
One visit, 30–75 minutes
Service call
$89 diagnostic, credited to the repair

Why it's happening, in order of likelihood

Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.

  1. 1

    Slow drain

    A partly blocked pump extends the drain step repeatedly until the control gives up or loops.

  2. 2

    Pressure switch or sensor

    The control never sees the tub reach the right level; it fills, pauses, fills.

  3. 3

    Unbalanced load / suspension

    The machine redistributes and retries the spin over and over, adding 20–40 minutes.

  4. 4

    Water temperature or heater

    Machines with internal heaters wait for temperature; a failed heater or thermistor stalls the cycle.

  5. 5

    Water inlet valve weak

    Slow fill makes every cycle long.

  6. 6

    Control board

    Software or relay fault; sometimes a power reset helps, but repeat offenders need the board.

Check these before you call

Safe, no-tools checks. If none of them solves it, the next step is a technician.

  • Clean the pump filter and check the drain hose.
  • Try a small balanced load.
  • Unplug the machine for 5 minutes and run a short cycle.

Parts we typically replace

  • Drain pump
  • Pressure switch / sensor
  • Suspension rods / shocks
  • Heater & thermistor
  • Water inlet valve
  • Control board

Brand-specific notes

  • LGLG front loaders retrying balance show the time jumping; worn shocks are the usual cause.
  • SamsungSamsung units that loop with SUD or 5UD have excess suds; cut detergent and clean the pump filter.

Repair or replace?

A repair.

What happens on the visit

1

Describe the symptom

Tell us the brand, model and what it's doing. A photo of the model tag helps.

2

We diagnose, you approve

$89 diagnostic, credited to the repair. Flat-rate quote before any work.

3

Fixed, usually that visit

Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.

Questions about this problem

Why does the time remaining keep going up?
The control is retrying a step: balancing, draining or filling. The cause is mechanical, not the clock.

Related washing machine problems

Washing Machine trouble? Same-day help.

Call or text (713) 548-7587 for a same-day appointment anywhere in Greater Houston. $89 diagnostic, credited toward your repair.

Call nowBook online