- Home
- Problems
- Oven & Range Repair
- Oven Door Locked
Oven door locked and won't open?
An oven door stuck locked, usually after a self-clean cycle, means the door lock motor, latch switch, control board or thermal fuse has failed. We release the door without damage and replace what failed.
- Most likely cause
- A failed door lock motor or a blown thermal fuse after self-clean
- Typical repair time
- One visit, 30–60 minutes
- Service call
- $89 diagnostic, credited to the repair
Why it's happening, in order of likelihood
Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.
- 1
Door lock motor or latch assembly
The motor that drives the latch fails, or the latch switch doesn't tell the control the door is unlocked.
- 2
Thermal fuse blown during self-clean
The oven lost power to the controls while locked; it stays locked.
- 3
Control board
The lock relay or the firmware won't release the latch.
- 4
Oven still hot
By design, the door stays locked until the cavity drops below about 500°F after self-clean. Wait an hour.
Check these before you call
Safe, no-tools checks. If none of them solves it, the next step is a technician.
- If self-clean just finished, wait for the oven to cool; it may unlock on its own.
- Turn the breaker off for 5 minutes and back on; some controls reset the latch.
- Don't pry the door; the latch will bend and the repair gets bigger.
Parts we typically replace
- Door lock motor / latch assembly
- Latch switch
- Thermal fuse
- Control board
Brand-specific notes
- WhirlpoolWhirlpool, KitchenAid, JennAir: F5 E1 is a latch fault.
- GE AppliancesGE: F9 is a door lock fault.
- FrigidaireFrigidaire: F90.
Repair or replace?
A repair.
What happens on the visit
Describe the symptom
Tell us the brand, model and what it's doing. A photo of the model tag helps.
We diagnose, you approve
$89 diagnostic, credited to the repair. Flat-rate quote before any work.
Fixed, usually that visit
Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.
Questions about this problem
Should I stop using self-clean?
Related oven, range & stove problems
Oven Not Heating
A weak gas igniter or a burned-out bake element.
See causes & fixesOven Temperature Not Accurate
A drifted temperature sensor or a weak igniter.
See causes & fixesElectric Stove Burner Not Working
A failed surface element or infinite switch.
See causes & fixesGas Burner Won't Light or Keeps Clicking
Moisture or debris on the spark electrode, or a failed igniter switch.
See causes & fixesOven Won't Turn Off or Overheats
A stuck relay on the control board or a shorted temperature sensor.
See causes & fixesBroiler Not Working
A failed broil element or broil igniter.
See causes & fixes