Codes appear on the oven display as F followed by a number (F2, F3, F7, F9), sometimes with a second code on newer controls. GE's advice is to disconnect power for 30 seconds; a code that returns needs service.
Models covered
Find the model number on the rating plate. Same locations as GE: inside the fresh-food section for refrigerators, on the door edge for dishwashers, on the frame for ranges.
- CGS / CES / CHS (slide-in)Gas (CGS700P2MS1, CGS750P2MS1), electric (CES700P2MS1) and induction (CHS900P2MS1) slide-in ranges.
- C2S / C2Y (dual-fuel & pro)Dual-fuel slide-ins (C2S900P2MS1) and 48-inch professional ranges (C2Y486P2TS1).
- CTS / CTD / CTC (wall ovens)Single, double and combination wall ovens (CTS70DP2NS1, CTD70DP2NS1).
Example model numbers
- CGS700P2MS1
- CGS750P2MS1
- CES700P2MS1
- CHS900P2MS1
- C2S900P2MS1
- CTS70DP2NS1
- CTD70DP2NS1
Café ranges and wall ovens run GE Profile controls and codes: F2 over-temperature, F3/F4 sensor, F7 stuck key, F9 door lock. The matte finishes and customizable hardware don't change the repair; induction models add generator boards that fail a zone at a time.
Café range & oven error codes
Filter by code or symptom. Meanings are the documented common ones for these platforms; the tech sheet inside your appliance is authoritative for your exact model.
| Code | What it means | What usually fixes it |
|---|---|---|
F0 / F1 | Keypad or control board fault (stuck key, failed touchpad or ERC) | Keypad ribbon or electronic range control. |
F2 | Oven over-temperature | Oven sensor, stuck relay or control. |
F3 | Oven temperature sensor open | Oven sensor or harness. |
F4 | Oven temperature sensor shorted | Oven sensor. |
F5 | Control board fault (watchdog / relay) | Electronic range control. |
F7 | Shorted or stuck key | Keypad or control. |
F9 | Door lock / latch circuit fault | Lock motor, latch switch or control. |
FC | Door lock circuit fault (some models) | Lock switch or control. |
No match in the main table; check the tables below or text us the code.
Messages that aren't faults
Things the display shows that don't mean a part has failed.
| Code | What it means | What usually fixes it |
|---|---|---|
PF | Power failure | Reset the clock. |
Common failures on these models
- Oven sensor faults (F3 / F4)
- Door lock faults after self-clean (F9)
- Induction generator board faults (one zone dead)
- Weak oven igniters on gas models
- Touch control faults from steam (F7)
Before you call
- Write down or photograph the exact code and which lights are lit before you reset anything; a reset can erase it.
- Reset once: switch the breaker off for 60 seconds, then back on. A code that returns is real.
- Check the basics the code points to (water valves open, drain hose not kinked, door fully closed, 240V breaker not half-tripped) using the table above.
- Text the code and a photo of the model tag to (713) 548-7587 so we arrive with the part.