Houston · Harris, Fort Bend & Montgomery counties
Mon–Sat 7am–7pmSame-day & next-day appointments (713) 548-7587
  1. Home
  2. Problems
  3. Dryer Repair
  4. Dryer Stops Mid-Cycle
Dryer Repair · Houston, TX

Dryer stopping mid-cycle?

A dryer that runs a few minutes then quits is usually overheating and shutting itself off, or losing contact through a worn door switch or a failing motor. We find which and fix it the same visit.

One visit, 30–75 minutes Same-day in most of Houston 1-year parts, 90-day labor warranty
Quick diagnosis
Most likely cause
Overheating from a restricted vent, a worn door switch or a failing motor
Typical repair time
One visit, 30–75 minutes
Service call
$89 diagnostic, credited to the repair

Why it's happening, in order of likelihood

Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.

  1. 1

    Thermal cutoff from overheating

    Restricted airflow trips the thermostat or the motor's internal overload; after cooling, it runs again.

  2. 2

    Door switch

    A worn switch loses contact as the drum vibrates, and the dryer stops as if the door opened.

  3. 3

    Drive motor overload

    A motor with worn bearings or a failing start winding overheats and trips its overload after 5–10 minutes.

  4. 4

    Moisture sensor

    Auto-dry cycles end early when the sensor reads dry because of a residue film or a wiring fault.

  5. 5

    Control board or timer

    Intermittent faults in the control.

Check these before you call

Safe, no-tools checks. If none of them solves it, the next step is a technician.

  • Check airflow at the exterior vent.
  • Wiggle the door during a cycle; if it stops, the switch is worn.
  • Clean the moisture sensor bars with rubbing alcohol.
  • Note whether it restarts after cooling (overheating) or immediately (switch/control).

Parts we typically replace

  • Door switch
  • Drive motor
  • Cycling thermostat
  • Moisture sensor
  • Control board

Brand-specific notes

  • SamsungSamsung dryers that stop and show dC/dE have a door switch or wiring fault.

Repair or replace?

A repair.

What happens on the visit

1

Describe the symptom

Tell us the brand, model and what it's doing. A photo of the model tag helps.

2

We diagnose, you approve

$89 diagnostic, credited to the repair. Flat-rate quote before any work.

3

Fixed, usually that visit

Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.

Questions about this problem

Why does my dryer stop after a few minutes but restart later?
It's overheating and tripping a protective thermostat or the motor overload. The vent is the first thing to check.

Related dryer problems

Dryer trouble? Same-day help.

Call or text (713) 548-7587 for a same-day appointment anywhere in Greater Houston. $89 diagnostic, credited toward your repair.

Call nowBook online