Houston · Harris, Fort Bend & Montgomery counties
Mon–Sat 7am–7pmSame-day & next-day appointments (713) 548-7587
  1. Home
  2. Problems
  3. Dishwasher Repair
  4. Dishwasher Not Starting
Dishwasher Repair · Houston, TX

Dishwasher not starting or no lights?

A dishwasher that is dead, lights up but won't start, or beeps and quits is usually the door latch, the control board, a thermal fuse, the touchpad or power. We work through them quickly.

One visit, 30–60 minutes Same-day in most of Houston 1-year parts, 90-day labor warranty
Quick diagnosis
Most likely cause
A failed door latch switch or control board
Typical repair time
One visit, 30–60 minutes
Service call
$89 diagnostic, credited to the repair

Why it's happening, in order of likelihood

Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.

  1. 1

    Door latch switch

    If the latch doesn't confirm the door is closed, nothing starts. Latches wear and door strikes bend.

  2. 2

    Control board

    Dead panel or a cycle that won't begin; sometimes a failed relay or power supply section.

  3. 3

    Thermal fuse

    Older Whirlpool and KitchenAid units have a fuse on the control board that blows and kills everything.

  4. 4

    Touchpad / user interface

    Buttons that don't respond or respond randomly.

  5. 5

    Power: breaker, junction box, air switch

    Dishwashers are often wired to a wall switch next to the disposal; the switch gets turned off by accident.

  6. 6

    Child lock, delay start or sleep mode

    Not failures, but common causes of 'it won't start'.

Check these before you call

Safe, no-tools checks. If none of them solves it, the next step is a technician.

  • Check the wall switch near the sink and the breaker.
  • Push the door firmly closed and listen for the latch click.
  • Look for a child lock indicator and hold the lock button for 3 seconds.
  • Turn the breaker off for 5 minutes to reset the control.

Parts we typically replace

  • Door latch assembly
  • Control board
  • Thermal fuse
  • Touchpad / UI board
  • Door switch

Brand-specific notes

  • WhirlpoolWhirlpool and KitchenAid units from the 2000s with no lights: thermal fuse or board.
  • BoschBosch dishwashers with lights but no start: door latch microswitch or control module.

Repair or replace?

Latches and fuses are cheap. A control board on a budget dishwasher over 10 years old may favor replacement.

What happens on the visit

1

Describe the symptom

Tell us the brand, model and what it's doing. A photo of the model tag helps.

2

We diagnose, you approve

$89 diagnostic, credited to the repair. Flat-rate quote before any work.

3

Fixed, usually that visit

Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.

Questions about this problem

My dishwasher starts then stops after a few seconds. Why?
The door latch is losing contact, or the control detected a fault such as a leak or an overfill.

Related dishwasher problems

Dishwasher trouble? Same-day help.

Call or text (713) 548-7587 for a same-day appointment anywhere in Greater Houston. $89 diagnostic, credited toward your repair.

Call nowBook online