- Home
- Problems
- Dishwasher Repair
- Dishwasher Not Cleaning Dishes
Dishwasher not cleaning dishes well?
Gritty glasses, food left on plates and a film on everything can be a weak wash pump, clogged spray arms, low water temperature, a failed inlet valve, or Houston's hard water. We test water pressure, temperature and spray coverage before replacing anything.
- Most likely cause
- Clogged spray arms, a weak circulation pump or hard-water scale
- Typical repair time
- One visit, 30–75 minutes
- Service call
- $89 diagnostic, credited to the repair
Why it's happening, in order of likelihood
Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.
- 1
Clogged spray arm nozzles
Scale and food block the small holes; spray pattern collapses. Houston's water makes this common.
- 2
Weak or failed circulation (wash) pump
The pump moves less water than designed; dishes on the top rack stay dirty first.
- 3
Water inlet valve or low fill
Not enough water enters, so the pump cavitates and cleaning drops.
- 4
Water not hot enough
Dishwashers need 120°F incoming water. Run the kitchen tap hot before starting the cycle.
- 5
Dirty filter
A packed filter recirculates dirty water.
- 6
Detergent dispenser not opening
The door doesn't release the pod; the dishes get rinsed, not washed.
- 7
Hard water film
White film that wipes off with vinegar is mineral deposit, not dirt. Rinse aid and a descaling cycle fix it.
Check these before you call
Safe, no-tools checks. If none of them solves it, the next step is a technician.
- Clean the filter and poke out the spray arm holes with a toothpick; spin the arms by hand to be sure they turn freely.
- Run the sink tap until hot before starting.
- Make sure the detergent dispenser isn't blocked by a tall item.
- Try a citric-acid dishwasher cleaner to rule out scale.
Parts we typically replace
- Circulation pump / wash motor
- Spray arms
- Water inlet valve
- Detergent dispenser
- Heating element
- Filter assembly
Brand-specific notes
- KitchenAidKitchenAid and Whirlpool: a failed wash motor is the most common cause of a sudden drop in cleaning.
- GE AppliancesGE: check the fine filter and the upper spray arm supply tube.
- BoschBosch: a heater fault (E09) leaves dishes cold and poorly cleaned.
Repair or replace?
Spray arms, valves and dispensers are cheap repairs. A wash motor on a budget dishwasher over 10 years old may favor replacement.
What happens on the visit
Describe the symptom
Tell us the brand, model and what it's doing. A photo of the model tag helps.
We diagnose, you approve
$89 diagnostic, credited to the repair. Flat-rate quote before any work.
Fixed, usually that visit
Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.
Questions about this problem
Why is only my top rack dirty?
Do I need rinse aid in Houston?
Related dishwasher problems
Dishwasher Not Draining
A clogged filter, food in the drain pump, or a blocked disposal inlet.
See causes & fixesDishwasher Leaking
A worn door gasket or a leaking pump seal.
See causes & fixesDishwasher Not Starting
A failed door latch switch or control board.
See causes & fixesDishwasher Not Drying
No rinse aid, or a failed heating element or vent fan.
See causes & fixesDishwasher Not Filling
A failed water inlet valve or a stuck float switch.
See causes & fixesDishwasher Making Loud Noise
Debris in the circulation or drain pump.
See causes & fixes