Faults show as Technical fault F-number or a plain message (Waterproof system fault, Check drainage, Water intake fault). Switch off and on once; a repeated fault needs service.
Models covered
Find the model number on the rating plate. Dishwashers: on the top edge of the door or the right side of the door frame. Washers and dryers: inside the door. Ovens: on the frame inside the door.
- WWB / WWH / WXD / WXF / WXR (W1)W1 front loaders: WWB020, WWH860, WXD160, WXF660, WXR860 with TwinDos and PowerWash.
- W 3xxx (classic, 2005–2016)W 3033, W 3038, W 3039, W 4840 and relatives.
- W 1xxx (older)W 1113, W 1213, W 1918 and others still in service.
Example model numbers
- WWB020 WCS
- WWH860 WCS
- WXD160 WCS
- WXF660 WCS
- WXR860 WCS
- W 3033
- W 4840
Miele washing machines report water intake (F10, F15), drainage (F11), heating (F20, F29), motor and pressure sensing (F51, F53) and electronics (F39–F47). The Waterproof system message means water was detected in the base pan from a hose, pump or drum seal, and the machine stops until it's found.
Miele washer error codes
Filter by code or symptom. Meanings are the documented common ones for these platforms; the tech sheet inside your appliance is authoritative for your exact model.
| Code | What it means | What usually fixes it |
|---|---|---|
F1 / F2 | Heater NTC fault | Temperature sensor. |
F10 | Water intake fault | Supply, filter, inlet valve. |
F11 | Drainage fault | Filter, pump, hose. |
F15 | Hot water intake fault | Hot supply or valve. |
F16 | Excessive detergent / foam | Reduce detergent. |
F19 | Flow meter slow | Flow meter. |
F20 | Heater fault | Heater. |
F29 | Steam heater fault | Steam heater. |
F39 / F41 / F45 | Electronic / EEPROM / data faults | Electronic unit. |
F46 / F47 | Display or interface fault | Display / interface. |
F51 | Pressure sensor fault | Pressure sensor. |
F53 | Speed sensor fault | Motor tach. |
F62 | Program selector fault | Selector. |
F63 / F64 | Water path control / path sensor fault | Water diverter. |
Waterproof system | Water detected in the base | Find the leak. |
No match in the main table; check the tables below or text us the code.
Common failures on these models
- Drainage faults (F11)
- Water intake faults (F10 / F15)
- Waterproof system trips
- Heater faults (F20)
- Pressure and speed sensor faults (F51 / F53)
- Door lock and drum bearing wear on older units
Before you call
- Write down or photograph the exact code and which lights are lit before you reset anything; a reset can erase it.
- Reset once: switch the breaker off for 60 seconds, then back on. A code that returns is real.
- Check the basics the code points to (water valves open, drain hose not kinked, door fully closed, 240V breaker not half-tripped) using the table above.
- Text the code and a photo of the model tag to (713) 548-7587 so we arrive with the part.