Codes display as E plus two characters (E20, E41, E64). On many models the stored code is retrieved by waking the machine, waiting 5 seconds, then holding Start/Pause and Cancel together; the code shows while the buttons are held.
- Home
- Brands
- Electrolux
- Washer
Electrolux Front-load washers: error codes & what they mean
26 codes explained for ELFW / EFLS / EFLW, EIFLS / EWFLS / EIFLW, ELFW4222 / EFLS210 models, with the part or problem behind each one. Same-day washing machine repair across Houston.
Models covered
Find the model number on the rating plate. Washers and dryers: inside the door rim. Refrigerators: inside the fresh-food section. Ovens: on the frame behind the door.
- ELFW / EFLS / EFLWCurrent front loaders with SmartBoost and Perfect Steam (ELFW7637AT, EFLS627UTT, EFLS527UTT, EFLW427UIW).
- EIFLS / EWFLS / EIFLW (2008–2016)IQ-Touch and Wave-Touch front loaders (EIFLS60LT, EWFLS70JIW, EIFLW55HIW).
- ELFW4222 / EFLS210 (compact)24-inch compact front loaders.
Example model numbers
- ELFW7637AT
- EFLS627UTT
- EFLS527UTT
- EFLW427UIW
- EIFLS60LT
- EWFLS70JIW
- EIFLW55HIW
Electrolux front loaders use the same E-code structure as Frigidaire's: E1x fill, E2x drain, E3x pressure sensing, E4x door lock, E5x motor and inverter, E6x heating, E7x temperature sensing, E9x communication. The premium models add internal heaters and steam, which brings the E6x and E7x codes into play more often.
Electrolux washer error codes
Filter by code or symptom. Meanings are the documented common ones for these platforms; the tech sheet inside your appliance is authoritative for your exact model.
| Code | What it means | What usually fixes it |
|---|---|---|
E10 | Water not entering / low pressure | Supply, hoses, inlet valve. |
E11 | Fill time too long | Inlet valve, screens, pressure. |
E13 | Water leak in tub or air leak in air bell | Leak or pressure hose. |
E20 / E21 | Water not pumping out fast enough | Drain pump obstruction, hose, pump. |
E23 / E24 | Drain pump relay fault | Control board. |
E31 | Pressure sensor not communicating | Pressure sensor or board. |
E35 | Pressure sensor indicates overfill | Inlet valve or sensor. |
E41 | Control thinks door switch is open | Door lock assembly. |
E42 | Door remains locked at end of cycle | Door lock. |
E43–E48 | Door lock assembly or control faults | Door lock or board. |
E52 | Bad signal from tacho generator | Motor tach or harness. |
E55 | Motor overheating | Motor or overload. |
E56 / E57 / E58 | High motor current / inverter current | Motor, inverter or harness. |
E59 | No tacho signal for 3 seconds | Motor tach. |
E5A / E5B / E5C | Heat sink too hot (motor control) | Motor control board. |
E5D / E5E / E5F | Communication problem with motor control | Harness or boards. |
E66 | Heater relay failure | Control board. |
E67 | Input voltage incorrect on board | Board or supply. |
E68 | Current leakage to ground on heater | Heater or fuse. |
E71 / E74 / E75 / E76 | Water temperature sensor (NTC) faults | Thermistor or harness. |
E82 / E83 / E93 / E94 | Console or control configuration faults | UI or control board. |
E91 / E95 / E97 / E98 | Communication errors between UI and control | Harness or boards. |
EB1 / EB2 / EB3 | Line frequency or voltage out of limits | Household supply. |
EF1 | Clogged drain pump | Pump cleaned or replaced. |
EF2 | Too much detergent | Reduce detergent. |
EF5 | Water temperature too high | Thermistor or heater relay. |
No match in the main table; check the tables below or text us the code.
Common failures on these models
- Drain pump obstructions (E20 / E21)
- Door lock faults (E41–E48)
- Heater relay and heater faults (E66 / E68)
- Motor and inverter codes (E52–E5F)
- Pressure sensor faults (E31 / E35)
- Door boot wear
Before you call
- Write down or photograph the exact code and which lights are lit before you reset anything; a reset can erase it.
- Reset once: switch the breaker off for 60 seconds, then back on. A code that returns is real.
- Check the basics the code points to (water valves open, drain hose not kinked, door fully closed, 240V breaker not half-tripped) using the table above.
- Text the code and a photo of the model tag to (713) 548-7587 so we arrive with the part.