Models with a temperature display show SY EF, SY CE, SY CF or H1/HI; sensor faults show OP (open) or SH (shorted) with the zone. Models without a display sound a high-temperature alarm or flash the light. Codes often appear after a power outage or a door left open.
- Home
- Brands
- Frigidaire
- Refrigerator & Freezer
Frigidaire Refrigerators & freezers: error codes & what they mean
7 codes explained for FFHS / FFSS / FGHS / FGSS / FRSS, FFHB / FGHB / FRFS / FRFC / LGHB, FFHT / FFTR / FRTD models, with the part or problem behind each one. Same-day refrigerator repair across Houston.
Models covered
Find the model number on the rating plate. Refrigerators: inside the fresh-food section on the ceiling or upper wall. Dishwashers: left side of the door. Ranges: on the frame behind the door or drawer. Washers: inside the door rim.
- FFHS / FFSS / FGHS / FGSS / FRSS (side-by-side)Side-by-side refrigerators (FFSS2615TS, FFSS2625TS, FGSS2635TF, FRSS2623AS).
- FFHB / FGHB / FRFS / FRFC / LGHB (French door)French door and counter-depth models (FFHB2750TS, FGHB2868TF, FRFS2823AS, FRFC2323AS, LGHB2869TF).
- FFHT / FFTR / FRTD (top-freezer)Top-freezer refrigerators (FFHT1835VS, FFTR1821TS, FFTR2021TS).
- FFFU / FFUE / FFCH / FFCS / FFFC (freezers)Upright (FFFU16F2VW, FFUE2022AW) and chest freezers (FFCS0922AW, FFFC15M4TW).
Example model numbers
- FFSS2615TS
- FGSS2635TF
- FFHB2750TS
- FGHB2868TF
- FRFS2823AS
- FFHT1835VS
- FFFU16F2VW
- FFCS0922AW
Frigidaire refrigerators report a short set of codes: SY EF is the evaporator fan circuit, SY CE and SY CF are board communication, H1 (sometimes HI) is a high-temperature alarm, and OP/SH identify an open or shorted thermistor. Most Frigidaire calls, though, show no code: ice makers and dispensers on side-by-sides, defrost failures on top-freezers, and fans on French door models.
After a Houston outage, H1 is common and usually just means the unit got warm while the power was out; if the compressor is running and temperatures are dropping, it clears. If not, the cooling system needs a look.
Frigidaire refrigerator & freezer error codes
Filter by code or symptom. Meanings are the documented common ones for these platforms; the tech sheet inside your appliance is authoritative for your exact model.
| Code | What it means | What usually fixes it |
|---|---|---|
SY EF | Evaporator fan circuit failure | Evaporator fan motor or harness; iced fan from a defrost fault. |
SY CE | Communication error between boards | Harness or control boards. |
SY CF | Communication failure at power-up | User interface or main board. |
H1 / HI | High temperature alarm | Check cooling; often appears after an outage or a door left open. |
OP (with zone) | Sensor open | Freezer or refrigerator thermistor. |
SH (with zone) | Sensor shorted | Thermistor or harness. |
PF | Power failure | Informational. |
No match in the main table; check the tables below or text us the code.
Messages that aren't faults
Things the display shows that don't mean a part has failed.
| Code | What it means | What usually fixes it |
|---|---|---|
Flashing temperature display | Door-open or high-temp alarm | Close the door; check the gasket. |
Common failures on these models
- Ice maker and dispenser faults on side-by-sides
- Evaporator fan faults (SY EF) and defrost failures
- Water inlet valve leaks behind the refrigerator
- Door gasket wear and sweating in humidity
- Start relay and compressor faults on older units
- Upright freezer defrost failures and frost buildup
Before you call
- Write down or photograph the exact code and which lights are lit before you reset anything; a reset can erase it.
- Reset once: switch the breaker off for 60 seconds, then back on. A code that returns is real.
- Check the basics the code points to (water valves open, drain hose not kinked, door fully closed, 240V breaker not half-tripped) using the table above.
- Text the code and a photo of the model tag to (713) 548-7587 so we arrive with the part.