- Home
- Problems
- Ice Maker Repair
- Undercounter Ice Machine Not Making Ice
Undercounter ice machine not making ice?
Standalone ice machines from Scotsman, U-Line, KitchenAid, GE, Perlick and others fail for different reasons than refrigerator ice makers. Scale buildup is the leading cause in Houston, followed by water valves, dirty condensers and bin or evaporator sensors.
- Most likely cause
- Scale buildup or a dirty condenser
- Typical repair time
- One visit, 1–2 hours including cleaning
- Service call
- $89 diagnostic, credited to the repair
Why it's happening, in order of likelihood
Our technicians test in roughly this order. The numbers reflect how often each cause turns out to be the fault on Houston service calls.
- 1
Mineral scale
Houston water leaves scale on the evaporator plate and in the water system. Ice gets thin, cloudy or stops releasing, and nugget augers bind. Descaling with manufacturer-approved cleaner restores production.
- 2
Dirty condenser
A clogged condenser raises pressures until the machine shuts down on a safety or produces slowly, especially in outdoor kitchens.
- 3
Water inlet valve or float
No water, or too little, reaches the reservoir.
- 4
Bin thermostat or ice level sensor
The machine thinks the bin is full and never starts.
- 5
Water pump or auger motor
Cubers need the pump to circulate water over the evaporator; nugget machines need the auger to turn.
- 6
Hot gas valve or sealed system
Ice forms but never releases (harvest fault), or the evaporator never gets cold.
Check these before you call
Safe, no-tools checks. If none of them solves it, the next step is a technician.
- Clean the condenser filter or grille.
- Look at the evaporator: a chalky white coating means scale.
- Confirm the water supply is on and the drain isn't backing up.
- Check the bin sensor for ice or debris holding it.
Parts we typically replace
- Water inlet valve
- Water pump
- Bin thermostat / sensor
- Auger motor
- Condenser fan
- Hot gas valve
Brand-specific notes
- ScotsmanScotsman Brilliance nugget machines show a clean light on schedule; running the cleaning cycle with Scotsman cleaner solves most low-production calls.
- U-LineU-Line clear ice machines are sensitive to water pump wear and evaporator scale.
- PerlickOutdoor Perlick ice makers need a condenser cleaning every few months in Houston.
Repair or replace?
These machines cost $1,500–$4,000 and are built for repair. Replace only if the sealed system fails on an old unit.
What happens on the visit
Describe the symptom
Tell us the brand, model and what it's doing. A photo of the model tag helps.
We diagnose, you approve
$89 diagnostic, credited to the repair. Flat-rate quote before any work.
Fixed, usually that visit
Common parts are on the truck. 1-year parts, 90-day labor warranty on the repair.